Tools

Free printable clay dog template for handbuilding

Pick the kind of dog you want to make. The template redraws at actual size, ready to print and build from.

Print the standard dog (PDF)

A ready-to-print PDF of the dog shown below with its standard settings and 12% shrinkage, on US Letter. Print it at 100% (“actual size”). To change the dog or the shrinkage, use the options below and print from this page instead.

Body
Ear size
Ears
Legs
Snout
Tail
Your clay

The template is drawn at building size, so the fired dog comes out the size you expect. Use the shrinkage on your clay’s product sheet.

Print at 100% (“actual size”), not “fit to page.” Then measure the 50 mm line at the top to check. Bigger dogs print on two pages.

Clay Manual · Dog templateBuild to these sizes. With 12% shrinkage the body fires to about 58 mm long.This line should measure 50 mmSide view, actual sizePieces, actual size (dashed lines are cutting lines)EarsCut 2 from a 4–5 mm slabSnoutCut 1, or model it solidLegsRoll 4 coils, 10 mm thickTail1 coil, tapering from 6 mmBody: 2 pinch potsRoll each from a 30 mm ball. Cut the gauge from card.rim 34 mm33 mm deepballHead: 2 pinch potsRoll each from a 21 mm ball. Cut the gauge from card.rim 28 mm14 mm deepball

Building it

  1. Body: roll two balls the size shown and pinch each into a pot. Cut the gauge from card and hold it against each pot as you pinch, until both match. Score, slip, and join the rims into an egg.
  2. Head: the same way, with the smaller gauge, joined into a ball.
  3. Add the legs, snout, ears, and tail. Score and slip every join.
  4. Leave a small hidden hole (under the belly works) so air can escape in the kiln.
  5. Check your dog against the side view as you go, then let it dry slowly under plastic.

About this template

This is a starting point we drew for our own handbuilding, not a pattern from a book. The proportions are simple on purpose, so you can change them as you build. Ear and snout outlines are for cutting from a slab; leg and tail outlines show how thick and long to roll each coil.

Printable clay dog template, standard settings: a side view of a small standing dog with pointed ears and a curled tail, the 50 mm scale line, cutting outlines for the ears, snout, legs, and tail, and card gauges for the body and head pinch pots.
The standard dog template as it prints, before you change any options. Open the PDF.

Our step-by-step build is in make a small clay dog with this template, and the shrinkage number is explained in our shrinkage notes. There is also a cat template. Tell us what other animals you would like.